Washer Extractor TWE060

• Quick warm up with less water and less energy, reach target concentration with less detergent, finally less dirty water.


• E.M.C. Certified (electromagnetic conformity), easy to use with question & answer principles, programmable for every type of garments control panel with LCD screen.


• Extra rinse wash, decrease in wrinkle, cancel in extraction, leaving in water, removing stains options.


• 3 water level controls that saves water consumption,


• Temperature control between 20 – 90°C


• Double water inlet, computerized heating regulation system


• Automatic detergent unit with 3 divisions, connectivity to the automatic dosing system.


• Advanced G Drive system


• Variable speed contol with frequancy inverter.


• The suspensioned structure that absorbs the vibration upto %95 – 98 and provides high extraction speed.


• Automatic load adjustment and balance system in case of over-lower loading and load distribution mistakes.


• Reinforced special design main shaft.


• Bearing house of low maintenance just to be checked at every 6 months and oil added, if necessary.


• Emptying system against the water and foam owerflows


• Safety swiches on loading door and other doors.


• 24 V voltage in all components for operators safety


• CE certified components in all electrical hardware


• Single motor system by frequency inverter.


• The main shaft enters to drum conically via formed (enforced) drum components underpress.By this way, the lifetime of the drum and shaft is maximized.


• Main shaft is guaranteed for 10 years against fractures.


• Bearing house,main shaft and inner drum are connected to each other by bolts and nuts.In this way, facility to technical service at site is, possible.


• The front and rear faces of the drum is formed under press and this enables the inner drum to rotate at constant circle.By this way,the distance between inner and outer drum is minimized.This distance is approx.2 cm.